251 - Rupture not working on recount
What steps will reproduce the problem?
1. when us rogue do a 5 combo point rupture with no poisons just a basic rupture, recount doesnt show full 10 ticks and damage, so rogue dps shows very low.
2. After doing the 5 combo point rupture check recount damage log and it is inconsistant and doesnt show full damage.
3.
What is the expected output? What do you see instead? It is supposed to show 10 ticks of rupture damage over 20 seconds but only show 3-5
What version of the product are you using?1137
Do you have an error log of what happened?
Please provide any additional information below.
recount shot low rupture ticks
- 1 comment
- 1 comment
Facts
- Last updated
- Oct 22, 2010
- Reported
- Oct 22, 2010
- Status
- New - Issue has not had initial review yet.
- Type
- Defect - A shortcoming, fault, or imperfection
- Priority
- Medium - Normal priority.
- Votes
- 0
- Component
- Recount
- Reply
- #1
wtrhzrd Oct 24, 2010 at 03:52 UTC - 0 likesI'm not seeing this (unless it was a fix and still shows as an active ticket). I just seen this ticket and went to the dummy in org to test. I built 5 CP's and did a rupture and then waited until the full duration completed. I checked my recount and it showed 10 ticks (5 CP's plus rupture glyph) just as expected.